Seiten

Freitag, 5. Januar 2018

Edelweiss - Flower Ornament

Where I live, carnival is quite important. I usually don't go to carnival events, but this season a friend had bought quite a few tickets and asked me whether I wanted to come and bring my mom. Only after I'd accepted I learned that I had to wear fancy dress for it :/
Since I already had a fancy dress dirndl, I decided to go for an "Alpine" look, by trying to create something like an edelweiss and wear it in my hair.
So, I crocheted several of these little edelweiss flowers and glued them onto small jaw clips. Of course, they can be used to decorate other objects as well ...
The pattern is given in written form and as a chart.


Creative Commons License
This work by Knitting and so on is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.






Materials
  • I used DK weight cotton
  • 3mm crochet hook
  • a tapestry needle to weave in ends
When I put 8 of these flowers on my kitchen scales, they showed about 10 grams. So, I guess 1 flower weighs about 1.5 grams, but since these scales are not exact with such a small weight, I cannot be exact.



Techniques
Besides, chain stitches, single crochets and slip stitches, you need to be able to do a magic ring. Here's a YouTube video by MJ Carlos that shows how to do it. If you don't want to do a magic loop, you can alternatively start with a ring of 6 chains, work rounds 2 and 3 and afterwards sew the little ring closed with your yarn tail.


Chart
On the right hand side you can see a chart of the pattern (click to enlarge).
Round 1 is a magic ring.
Round 2 consists of petals that are worked into the back loops of the sc's of the magic ring.
Round 3 consists of petals that are worked into the front loops of the same sc's.
Since rounds 2 and 3 are basically worked on top of each other, there are charts for each round, the rounds that have already been worked are depicted in light grey.


Instructions

Round 1: Do a magic ring, and work 6 sc into the ring (your piece should now look like illustration 1), close the ring with a slip stitch and draw the loop closed

Round 2 (outer, bigger petals): sl st into the back loop of the first sc, do five chain sts (4 chains and 1 turning chain, see illustration 2), do 4 sc's into the chains and connect to ring by doing a slip st into the back loop of the next sc - this loop is marked pink in illustration 2. Now your piece should look similar to illustration 3.
Repeat 4 more times, the back loops into which to place the slip stitches are marked pink in illustration 4.
For the sixth petal do 5 chains and 4 sc's into the chains and connect the last petal with a slip stitch into the front loop of the first sc of the ring.

Round 3 (inner, smaller petals): do 3 chain sts (2 chains and 1 turning chain), do 2 sc's into the chains and connect to ring with a slip stitch into the front loop of the next sc of the ring.
Repeat 4 more times.
For the sixth petal, do 3 chains and 2 sc's into the chains and connect to the ring with a slip stitch into the front loop of the first sc of the ring

Fasten off and weave in ends.




3 Kommentare: