So, here is the pattern for a flower-shaped potholder, hotpad or coaster. It starts with a provisional CO, is knitted in short row wedges and finished with grafting in garter stitch.
Since this is an intarsia project with three colours that also uses short rows, it can be quite fiddly. It is NOT a beginner pattern.
The pattern is available
- on Ravelry
- on Loveknitting
- on Payhip
The pattern PDF is 12 pages long and contains
- written row-by-row instructions for knitting this piece – including four photos of the different stages
- a pattern chart of one wedge
- short photo tutorials for the following techniques
- provisional CO with a crochet hook and how to undo it
- grafting in garter stitch
- short rows with wrap and turn and picking up the wraps
- intarsia knitting
- weaving in yarn while carrying it (backwards and forwards)
- photo tutorials and step-by-step explanations of
- undoing the provisional CO in this pattern (i.e. catching stitches in different colours)
- grafting this piece – with a decrease and colour changes
Since it's an intarsia pattern, it looks OK from WS as well (see picture below).
- Cotton yarn in three colors – I knitted these potholders in Aran and Sports weight yarn
- for Aran, I used a total of 30 grams
- for Sports weight, I used a total of 20 grams
- knitting needles – straight or circulars: I used 3mm needles for Aran weight yarn and 2.5mm needles for Sports weight yarn, i.e. smaller than the yarn usually requires because I wanted a firm texture.
- scrap yarn and a crochet hook (about 3mm) for the provisional CO
- two tapestry needles for grafting and to weave in ends
The pieces I knitted measure 16 cm to 22 cm in diameter - depending on the yarn weight I used.
These are lovely. You have some beautiful patterns on your blog :)
AntwortenLöschen